Bracket Kit Install Guide

For thin bezels and OLED screens. One bracket per light bar, seven in the kit. About five minutes.

1. What's in the box

An L-bracket with its double-sided tape on top, next to a loose 3M Command Strip
Each bracket arrives with double-sided tape already on top. The 3M Command Strips come loose, one per bracket.

2. Add the Command Strip

A Command Strip being applied to the bracket, aligned with its bottom edge
Stick a Command Strip to the bracket just below the tape, lined up with the bottom edge of the bracket so it stays clear of the sliding channel. Leave the liner marked WALL on for now.

3. Peel the tape cover

Peeling the brown cover off the tape on top of the bracket
Peel the brown cover off the double-sided tape on top of the bracket.

4. Attach it to the light bar

Pressing the bracket onto the center of the back of a light bar
Press the bracket onto the center of the light bar and hold it firmly. Same spot on the original long bars and the short Audio Radar 2.0 bars.

5. Check it

A light bar with the bracket attached, Command Strip on the same side as the bar's lip
The Command Strip should sit on the same side as the lip of the light bar.

6. Put it on the monitor

Placing the light bar on top of a thin monitor and pressing the bracket to the back
Peel the WALL liner off the Command Strip. Hook the lip of the light bar over the front of the monitor, lay the bar flat, then press the bracket firmly to the back of the monitor.

7. Done, from behind

Rear view of a light bar mounted on a thin monitor with the bracket centered
This is a finished install from the back. Repeat for each light bar.

8. Done, from the side

Side view of a light bar sitting on top of a thin monitor
The bar sits on top of the monitor with its lip over the front edge.

To take a bar off later, pull the white Command Strip tab slowly, straight down along the monitor.

Stuck? Message support and send a photo of your setup. We will get you sorted.